Blog

A thermic fluid heater is inherently safer than a comparable high-pressure steam boiler — that’s a large part of why

Fuel is usually the single largest recurring cost of running process heat in an industrial plant, which means efficiency isn’t

Food processing has a heating requirement most other industries don’t: the heat source has to be indirect, precisely controlled, and

Plastics processing runs on temperature control. A few degrees too hot or too cold at the mold, the die, or

Call out enough thermic fluid heater breakdowns across enough plants, and you start seeing the same nine or ten problems

Plastics processing runs on temperature control. A few degrees too hot or too cold at the mold, the die, or

Call out enough thermic fluid heater breakdowns across enough plants, and you start seeing the same nine or ten problems

A thermic fluid heater is built to run for decades. We’ve seen units in the field cross 20 years of

A thermic fluid heater is only as good as the fluid running through it. The heater coil, pump, and control

It’s one of the most common questions we field at Balkrishna Boilers Pvt Ltd: “Should this process run on a

Ask any process engineer working with high-temperature industrial heat, and thermic fluid heaters will come up early in the conversation.